-
Photo resistors, also known as light dependent resistors (LDR), are light sensitive devices most often used to indicate the presence or absence of light, or to measure the light intensity.
LDR Sensor
NPR 25.00 -
-14%
- IR Infrared Obstacle Avoidance Sensor Module can be widely used in robot obstacle avoidance, obstacle avoidance car, line count, and black and white line tracking and so on
- the module detects the distance 2 ~ 30cm, detection angle 35 °, the distance can detect potential is adjusted.
- Can be used for 3-5V DC power supply modules.
IR Infrared Obstacle Avoidance Sensor Module
NPR 300.00 -
The TCS3200 programmable color light-to-frequency converter combines configurable silicon photodiodes and a current-to-frequency converter on a single monolithic CMOS integrated circuit. The output is a square wave (50% duty cycle) with frequency directly proportional to light intensity (irradiance). The TCS3200 reads an 8×8 array of photodiodes.
TCS 3200 (Color Sensor)
NPR 680.00 -
This Liquefied Petroleum Gas (LPG) sensor is suitable for sensing LPG (composed of mostly propane and butane) concentrations in the air. It can detect gas concentrations anywhere from 200 to 10000ppm. This sensor has a high sensitivity and fast response time. The sensor’s output is an analog resistance. The drive circuit is very simple; all you need to do is power the heater coil with 5V, add a load resistance, and connect the output to an ADC.
LPG Gas Sensor (MQ6)
NPR 550.00 -
Arduino Sensor Shield is a board used to connect sensors, servos, LCD with the Arduino Board without the requirement of soldering. Using Arduino Board separately you’ll find a few of 5V and GND connections. Arduino Sensor Shield gives you the ability of dedicated one 5V and GND connection for every Arduino signal pin.
Arduino Sensor Shield
NPR 500.00 -
The emitter is an IR LED and the detector is an IR photodiode. The IR phototdiode is sensitive to the IR light emitted by an IR LED. The photo-diode’s resistance and output voltage change in proportion to the IR light received. This is the underlying working principle of the IR sensor.
IR Sensor(Photodiode)
NPR 19.00 -
This is Carbon Monoxide sensor is suitable for sensing CO concentrations in the air. The MQ-7 can detect CO-gas concentrations anywhere from 20 to 2000ppm.This sensor has a high sensitivity and fast response time. The sensor’s output is an analog resistance. The drive circuit is very simple; all you need to do is power the heater coil with 5V, add a load resistance, and connect the output to an ADC.
Carbon Monoxide Sensor (MQ7 | MQ-7)
NPR 550.00 -
This capacitive touch sensor module uses the TTP229 integrated circuit, making it easy to add capacitive touch input for projects. It features 16 sensitive touch pads that make an ideal replacement for the traditional keypads.
16 Channel Digital Capacitive Switch Touch Sensor Module
NPR 350.00 -
DHT22 capacitive humidity sensing digital temperature and humidity module is one that contains the compound has been calibrated digital signal output of the temperature and humidity sensors. Application of a dedicated digital modules collection technology and the temperature and humidity sensing technology, to ensure that the product has high reliability and excellent long-term stability.
Temperature Humidity Sensor DHT-22 Module
NPR 620.00 -
The vibration sensor module based on the vibration sensor SW-420 and Comparator LM393 is used to detect vibrations. The threshold can adjust using an on-board potentiometer. During no vibration, the sensor provides Logic Low and when the vibration is detected, the sensor provides Logic High.
Vibration Sensor Module
NPR 350.00 -
-19%
Take your sonar outside – great for all weather robots! The XL-MaxSonar-WRMA1 ignores smaller targets and only reports the range to target with the largest acoustic return. This is our most advanced weather resistant sensor designed for target detection and ranging outdoors or in tank or bin applications.
Waterproof ultrasonic sensor
NPR 890.00 -
TMP36 is a wide range, low power temperature sensor that outputs an analog voltage that is proportional to the ambient temperature.
TMP36 Temperature Sensor
NPR 250.00 -
- Technical parameters
- power 5V DC
- maximum working current < 10mA
- operating frequency ID 125KHz 、IC 13.56MHZ
- supports
- ID:EM4100 and its compatible cards
- IC:Reader Out format
- MF1 Classic S50,S70,FM1108,MF Plus 4bit, NTAG213,NTAG215,NTAG216,
- support management card configuration
- card sensing speed is less than 200ms
- operating temperature 60 C 0
- 10% ~ 95% (no humidity dew)
- Operating environment
- WinXP, Win7, Win8, Android-OTG, etc., in theory, as long as the USB keyboard to support the computer or mobile phones can use this product.
- Using method
- the use of the configuration card configuration card, the card is 3 seconds. The configuration of red, blue flash alternately exhibit of lanterns.
Portable USB RFID Sensor 125 KHz
NPR 3,000.00 -
Water Level Sensor is easy-to-use, cost effective high level/drop recognition sensor, which is obtained by having a series of parallel wires exposed traces measured droplets/water volume in order to determine the water level.
Water Sensor
NPR 449.00 -
-22%
Model: SCT-013-000
Rated input current:0-100A.
Output: 0-50mA or 0-1V.
Split Core Current Sensor Transformer SCT013
NPR 1,560.00 -
Widely used in motor speed detection, pulse-counting, any position, possesses 2 road testing.
Two Way Velocimetry Sensor Module XD 211
NPR 550.00 -
Accurate sensor to measure AC/DC current up to 20A. The sensor can even measure high AC mains current and is still isolated from the measuring part due to integrated hall sensor. The board operates on 5V. ACS712 current sensor operates from 5V and outputs analog voltage proportional to current measured on the sensing terminals. You can simple use a microcontroller ADC to read the values.
20A Hall Current Sensor ACS712-20A
NPR 480.00 -
This is a simple water sensor can be used to detect soil moisture when the soil moisture deficit module outputs a high level, and vice versa output low. Use this sensor produced an automatic plant waterer device, so that the plants in your garden without people to manage.
Soil Hygrometer Detection Sensor Module
NPR 450.00 -
HX711 is an electronic scale module, whose working principle is to convert the measured changes in resistance value changes, through the conversion circuit into electrical output. The module communicates with the host computer through TTL 232.
HX711 Dual-Channel Weighing Sensor Module
NPR 400.00 -
- Product Model: FSR402:
- Size: thick (12.5 mm) in diameter, 1/2 “for the active field
FSR is Force Sensitive Resistor, allowing you to detect the physical pressure, extrusion, and weight.They are simple using, low cost.
FSR is delimited by two layer, as the pressure increases, the activity of these elements point will touch the semiconductor, making resistance smaller
Force Sensitive Resistor Sensor (FSR402)
NPR 1,950.00 -
Gas Sensor(MQ5) module is useful for gas leakage detection (in home and industry). It is suitable for detecting H2, LPG, CH4, CO, Alcohol. Due to its high sensitivity and fast response time, measurements can be taken as soon as possible. The sensitivity of the sensor can be adjusted by using the potentiometer.
Gas Sensor(MQ5)
NPR 500.00 -
Gas Sensor(MQ9) module is useful for gas leakage detection (in home and industry). It is suitable for detecting LPG, CO, CH4. Due to its high sensitivity and fast response time, measurements can be taken as soon as possible. The sensitivity of the sensor can be adjusted by using the potentiometer.
Gas Sensor (MQ9)
NPR 550.00 -
This gas sensor for monitoring indoor air qualit. it is suitable for sensing NH3, NOx, alcohol, Benzene, smoke and CO2 in the air. The MQ-135 can detect NH3 and Alcohol gas concentrations anywhere from 10-300ppm and Benzene from 10-1000ppm. This sensor has a high sensitivity and fast response time. The sensitivity of the sensor can be adjusted by potentiometer.
Gas Sensor (MQ135)
NPR 550.00 -
This hydrogen gas sensor is suitable for sensing hydrogen concentrations in the air. It can detect hydrogen gas concentrations anywhere from 100-10000ppm. This sensor has a high sensitivity and fast response time. The sensor’s output is an analog resistance. The drive circuit is very simple; all you need to do is power the heater coil with 5V, add a load resistance, and connect the output to an ADC.
Hydrogen Gas Sensor (MQ8)
NPR 550.00 -
Gas Sensor(MQ2) module is useful for gas leakage detection (home and industry). It is suitable for detecting H2, LPG, CH4, CO, Alcohol, Smoke or Propane. Due to its high sensitivity and fast response time, measurement can be taken as soon as possible. The sensitivity of the sensor can be adjusted by potentiometer.
Smoke Gas Sensor (MQ2)
NPR 550.00 -
It is a MAX6675 thermocouple which is a cold junction compensation, linearity coorection, thermocouple break detection ADC Serial K-type thermocouple, its temperature resolution capability is 0.25 Degree, cold unctioncompensatrion range is -20 to +80’C, wide operqating range 3.0 to 5.5 V.
Thermocouple Temperature Sensor
NPR 550.00 -
An assortment of the most common sensors used in electronics.
9 sensors and 3 additional components to interface with the “analog world.”Sensor pack 900 (pre-kitted) by adafruit
NPR 3,600.00 -
A pair of infrared sensor and a 21 keyed remote control.
Infrared Sensor + Remote Control
NPR 500.00 -
Product Features
- Working voltage:DC 3.3-5V
- Dimension: Approx.4.5(L) x 1.7(H) x 0.9(W)cm
- Main chip: LM393, Electret condenser microphone
- Package Included: 1 x Sound Detection Sensor Module
Sound Detection Sensor Module
NPR 250.00 -
This module integrates DHT11 sensor and other required components on a small PCB. The DHT11 sensor includes a resistive-type humidity measurement component, an NTC temperature measurement component and a high-performance 8-bit microcontroller inside, and provides calibrated digital signal output.
Note: The cable is not included in the pack
Temperature Humidity Sensor DHT- 11 Module
NPR 500.00 -
The rain sensor module is an easy tool for rain detection. It can be used as a
switch when raindrop falls through the raining board and also for measuring rainfall
intensity. The module features, a rain board and the control board that is separate for
more convenience, power indicator LED and an adjustable sensitivity though a
potentiometer. The analog output is used in detection of drops in the amount of rainfall.
Connected to 5V power supply, the LED will turn on when induction board has no rain
drop, and DO output is high. When dropping a little amount water, DO output is low, the
switch indicator will turn on. Brush off the water droplets, and when restored to the initial
state, outputs high level.Raindrops Sensor Module MH-RD
NPR 350.00 -
BreadFruit Electronics | | Buy latest Arduino, Sensors, Raspberry Pi, ICs, Resistors and other electronic components in Nepal
