Best Seller Items
Featured Items
-
3.5 inches touch screen module is designed especially for Raspberry Pi. It transmits data though GPIO, SPI (Serial Peripheral Interface) on the P1 interface. The CPLD on the display module controls display content according to the data transmitted from the SPI interface.
Raspberry Pi 3.5” TFT with touch screen
NPR 3,000.00 -
The Official Raspberry Pi power supply
Easily interchangeable heads for the UK, US, EU and Australia you can now use your Pi in all four corners of the world!
- +5.1V 2.5A output provides all the power your Pi will need
- 1.5m cable gives your Pi room to manoeuvre
- Micro USB connection goes straight into your Pi’s power supply
Official Raspberry Pi 3 Universal Power Supply
NPR 2,000.00 -
- SanDisk Ultra microSDHC UHS-1 (Micro SD Card)
- 16 GB Menory
- 98MBps transfer speed
- UHS 1
Can be used for Raspberry pi and other purpose.
SanDisk Ultra micro SD Card 16 GB (For Raspberry Pi)
NPR 550.00 -
-
-
AVR microcontrollers can utilize an interface called In-System-Programming. ISP allows the chip to be programmed or reprogrammed while in an actual circuit via a pin header. Atmel’s solution is the AVR ISP MKII programing tool. The MKII can also be reprogrammed just as an AVR.
USB-ISP AVR Programmer with Ten Pin USB-ISP Cable
NPR 450.00 -
- This is a module used for ease of use compared to the bulky traditional serial (DB9) port.
- 100% Brand new and high quality
- Adopt imported controller RS232 TTL, which can stabilize the flash with high speed
- 500mA self-recovery fuse for protection
Two data transmission indicator can monitor data transfer status in real time
Reserve 3.3V and 5V pin interface for easy operation
The entire board is coated by the high quality transparent heat-shrinkable sleeve, making the PCB in insulation state from outside
The electrostatic package ensures the board will not be damaged before useUSB To RS232 TTL Auto Converter Module
NPR 480.00 -
Annoying that the programmer has 10 pins, while the Arduino boards only have 6 pins! That leads to a lot of loose wires and faulty connections. This 10 to 6 pin adapter for the USBASP avr programmer is guaranteed to solve this problem.
Technical Specifications –
No. of Pin on USBASP side: 10.
No. of Pin on Device under programming side: 6.
Connector type on USBASP side: Male.
Connector type on Device under programming side: Female.USB-ASP Adapter
NPR 120.00 -
This is an USBasp programmer for uploading source codes (Programs that run your electronic devices from your microwave to your quad-copter) to a Micro-controller unit using standard USB port as input, and the 10 on-board pins as output, and the 6 pins ICSP converter, you can use this to program your arduino with ease.
USBASP AVR Programmer(with wire)
NPR 480.00 -
The UA741 is a high performance monolithic operational amplifier constructed on a single silicon chip.
UA741 General Purpose Op-Amp
NPR 100.00 -
-
The 4N35 is an optocoupler for general purpose applications.It contains a light emitting diode optically coupled to a photo-transistor
EL 4N35 712 Octocoupler
NPR 50.00 -
The ULN2003A is an array of seven NPN Darlington transistors capable of 500 mA, 50 V output. It features common-cathode flyback diodes for switching inductive loads. It can come in PDIP, SOIC, SOP or TSSOP packaging.[1][2] In the same family are ULN2002A, ULN2004A, as well as ULQ2003A and ULQ2004A, designed for different logic input levels.
ULN 2003A
NPR 89.00 -
The ATmega328 is a single-chip microcontroller created by Atmel in the megaAVR family (later Microchip Technology acquired Atmel in 2016). It has a modified Harvard architecture 8-bit RISC processor core.
AT mega 328
NPR 350.00
