-
- Hole distance: 16MM
- Aperture: 2.5MM
- Voltage range: 2.4-5V
- Maximum output current: 500MA
- PCB size: L23MM *W20MMThe lamp brightness can be adjusted by requirement, it is very to operate.
It can touch in medium protection, such glass, acrylic, plastic, ceramics and so on, which is very safe.
Wide application of voltage range, you can choose arbitrarily between 2.4V to 4.5V.
Simple applied circuit, less peripheral devices, easy processing, low cost.
Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not affected by the close distance or multi-angle mobile phone interference.
Install: Neednrsquo;t to touch copper foil directly,the dimming can be processed across the acrylic glass(above 3mm) or plastic.
Application: It can control LED module, light and so on.It is available for indoor LED, lighting lamp,DIY automotive lights dimming refit.
Function:Single touch,using the principle of capacitance touch.The default function is switch, dimming, with brightness memories LED touch dimming.It will light slowly when turn on the lights, and become dark slowly when turn off, which effectively avoid the stimulation to eyes.
Dimming mode: Non-polar PWM dimming.
Wiring method: PCB board(VCC,GND) is power input,(LED+, LED-) is connected with the LED lamps of positive and negative level (fingerprint) touch area.
Capacitive Touch Dimmer
NPR 250.00 -
The vibration sensor module based on the vibration sensor SW-420 and Comparator LM393 is used to detect vibrations. The threshold can adjust using an on-board potentiometer. During no vibration, the sensor provides Logic Low and when the vibration is detected, the sensor provides Logic High.
Vibration Sensor Module
NPR 350.00 -
MAX31865 RTD Platinum Resistance Temperature Detector PT100 to PT1000
The MAX31865 is an easy-to-use thermistor-to-digital output converter optimized for platinum resistance temperature detectors (RTDs). The external resistor sets the RTD sensitivity, and the high precision Δ- Σ ADC converts the ratio of the RTD resistor to the reference resistor into a digital output. The MAX31865 has overvoltage protection up to ±45V and provides configurable RTD and cable open and short-circuit condition detection.
MAX31865 RTD Platinum Resistance Temperature Detector Module (PT100 to PT1000)
NPR 850.00 -
The DC-DC module based on LM2596 advocate current to 3.0A, but only to 1.8A.However, being introduced module adds a heatsink, using high-power devices.This module can easily reach 4A, 50W, add heat sink circumstances can reach 75W
XL 4015 Buck Module
NPR 600.00 -
p+/p- input/output interface, the same combination when the battery voltage, capacity, internal resistance should be matched well, battery voltage around the rated voltage of 3.7v, combination without output, after the completion of voltage charging activation by 7.4v.
2S 8A Li-ion 7.4v 8.4V 18650 BMS PCM 15A Peak Current Battery Protection Board
NPR 400.00 -
BreadFruit Electronics | | Buy latest Arduino, Sensors, Raspberry Pi, ICs, Resistors and other electronic components in Nepal
