Best Seller Items
Featured Items
-
4 Channel Relay Module (5v)
NPR 500.00This is a 5V 4-channel relay or four channel relay module interface board, and each channel needs a 15-20mA driver current. It can be used to control various appliances and equipment with large current. It is equiped with high-current relays that work under AC250V 10A or DC30V 10A. It has a standard interface that can be controlled directly by microcontroller.
- Size: 75mm (Length) * 55mm (Width) * 19.3mm (Height)
- Weight: 61g
- PCB Color: Blue
- There are four fixed screw holes at each corner of the board, easy for install and fix. The diameter of the hole is 3.1mm
- High quality Songle relay is used with single pole double throw, a common terminal, a normally open terminal, and a normally closed terminal
- Optical coupling isolation, good anti-interference.
- Closed at low level with indicator on, released at high level with indicator off
- VCC is system power source, and JD_VCC is relay power source. Ship 5V relay by default. Plug jumper cap to use
- The maximum output of the relay: DC 30V/10A, AC 250V/10A
-
Temperature Humidity Sensor DHT- 11 Module
NPR 500.00This module integrates DHT11 sensor and other required components on a small PCB. The DHT11 sensor includes a resistive-type humidity measurement component, an NTC temperature measurement component and a high-performance 8-bit microcontroller inside, and provides calibrated digital signal output.
Note: The cable is not included in the pack
-
Infrared Sensor + Remote Control
NPR 500.00A pair of infrared sensor and a 21 keyed remote control.
-
IIC Serial White OLED Display Module
NPR 500.000.96 inch IIC Serial White OLED Display Module 128X64 (Yellow-Blue, & just Blue)
-
Gas Sensor(MQ5)
NPR 500.00Gas Sensor(MQ5) module is useful for gas leakage detection (in home and industry). It is suitable for detecting H2, LPG, CH4, CO, Alcohol. Due to its high sensitivity and fast response time, measurements can be taken as soon as possible. The sensitivity of the sensor can be adjusted by using the potentiometer.
-
Arduino Sensor Shield
NPR 500.00Arduino Sensor Shield is a board used to connect sensors, servos, LCD with the Arduino Board without the requirement of soldering. Using Arduino Board separately you’ll find a few of 5V and GND connections. Arduino Sensor Shield gives you the ability of dedicated one 5V and GND connection for every Arduino signal pin.
-
IDC 20 Pins Rainbow/Gray Color 2.54mm Pitch 48/66/118/128cm Long Flat Bendable Ribbon Jumper Cable Female Connector
NPR 540.0020 Pins Connector Flat Ribbon Cable,2.54mm Pitch
Easily and directly inserted into PCB
Suitable for internal wiring in office equipment, audio and video machines
-
Water level sensor (vertical)
NPR 550.00A float switch is a device used to sense the level of liquid within a tank. Products can be used for drinking fountains, water heaters, solar, air conditioners, humidifiers, bathroom equipment, vending machines, etc. This is a mini float switch. Contains no mercury.
-
-
MP3 Decoder Module
NPR 550.00This is one of the simplest mp3 player module for electronics enthusiasts. Simply insert a MicroSD card, power up the board and play any song/audio.
Supports mp3 format audio files.
Connect a speaker and an earphone to the board and enjoy your audio.
The circuit board has an inbuilt 2W mono amplifier.
-
Thermocouple Temperature Sensor
NPR 550.00It is a MAX6675 thermocouple which is a cold junction compensation, linearity coorection, thermocouple break detection ADC Serial K-type thermocouple, its temperature resolution capability is 0.25 Degree, cold unctioncompensatrion range is -20 to +80’C, wide operqating range 3.0 to 5.5 V.
-
LPG Gas Sensor (MQ6)
NPR 550.00This Liquefied Petroleum Gas (LPG) sensor is suitable for sensing LPG (composed of mostly propane and butane) concentrations in the air. It can detect gas concentrations anywhere from 200 to 10000ppm. This sensor has a high sensitivity and fast response time. The sensor’s output is an analog resistance. The drive circuit is very simple; all you need to do is power the heater coil with 5V, add a load resistance, and connect the output to an ADC.
-
Smoke Gas Sensor (MQ2)
NPR 550.00Gas Sensor(MQ2) module is useful for gas leakage detection (home and industry). It is suitable for detecting H2, LPG, CH4, CO, Alcohol, Smoke or Propane. Due to its high sensitivity and fast response time, measurement can be taken as soon as possible. The sensitivity of the sensor can be adjusted by potentiometer.
-
Carbon Monoxide Sensor (MQ7 | MQ-7)
NPR 550.00This is Carbon Monoxide sensor is suitable for sensing CO concentrations in the air. The MQ-7 can detect CO-gas concentrations anywhere from 20 to 2000ppm.This sensor has a high sensitivity and fast response time. The sensor’s output is an analog resistance. The drive circuit is very simple; all you need to do is power the heater coil with 5V, add a load resistance, and connect the output to an ADC.
-
Hydrogen Gas Sensor (MQ8)
NPR 550.00This hydrogen gas sensor is suitable for sensing hydrogen concentrations in the air. It can detect hydrogen gas concentrations anywhere from 100-10000ppm. This sensor has a high sensitivity and fast response time. The sensor’s output is an analog resistance. The drive circuit is very simple; all you need to do is power the heater coil with 5V, add a load resistance, and connect the output to an ADC.
