Best Seller Items
Featured Items
-
-
-
-
-
Widely used in TV, automobile electronics, PC cards, electronic meter, DVD, MP3, etc. An ideal accessory part with high quality.
Crystal oscillator 32.768KHz
NPR 35.00 -
-
8 MHz Crystal Oscillator. Crystal oscillators are oscillators where the primary frequency determining element is a quartz crystal. Because of the inherent characteristics of the quartz crystal the crystal oscillator may be held to extreme accuracy of frequency stability. Temperature compensation may be applied to crystal oscillators to improve thermal stability of the crystal oscillator.
Crystal oscillators are usually, fixed frequency oscillators where stability and accuracy are the primary considerations. For example it is almost impossible to design a stable and accurate LC oscillator for the upper HF and higher frequencies without resorting to some sort of crystal control. Hence the reason for crystal oscillators.
Crystal oscillator 8MHz
NPR 35.00 -
D2SBA60 is a 600V 1.5A Flat Bridge Rectifier. It is a full wave rectifier.
D2SBA60 Bridge Rectifier
NPR 50.00 -
DB-2 micro pump motor for water dispenser water priming pump, automotive pump, RC toy experiment pump, aquarium bonsai rockery.
DB2 Dc Pump 8to12v
NPR 500.00 -
DC 3V 450mA Micro 370 Air Pump / Fishing Pump / Oxygen Pump
DC 3V 450mA Micro 370 Air Pump / Fishing Pump / Oxygen Pump
NPR 600.00 -
-
-
Desoldering Wire Braid Sucker 2.0mm (1.5meter)
Desoldering braid, also known as desoldering wick or solder wick, is finely braided 18 to 42 AWG copper wire coated with rosin flux, usually supplied on a roll.The end of a length of braid is placed over the soldered connections of a component being removed. The connections are heated with a soldering iron until the solder melts and is wicked into the braid by capillary action.
Desoldering Braid
NPR 199.00 -
MaterialPlasticAutomation GradeManualNo. of sets1Is It PortablePortableModel Number/NameDesoldering Pump
Desoldering Pump
NPR 190.00 -
3-Axis Digital Accelerometer is the key part in projects like orientation detection, gesture detection and Motion detection.
Digital Accelerometer ADXL 345
NPR 599.00 -
This module is based on the I2C light-to-digital converter TSL2561 to transform light intensity to a digital signal. Different from the traditional analog light sensor, this digital module features a selectable light spectrum range due to its dual light-sensitive diodes: infrared and full spectrum.
You can switch among three detection modes to take your readings. They are infrared mode, full spectrum, and human visible mode. When running under the human visible mode, this sensor will give you readings just close to your eye feelings.
Digital Light Sensor Module (TSL2561)
NPR 800.00 -
The DT830D is a cheap and best digital multimeter made in China. It is capable of measuring voltage, current, resistance, transistor, diode, and has a signal generator function. It cannot measure capacitor values.
Digital Multimeter DT830D
NPR 380.00 -
Digital Signage Screen for your hotels, restaurants, and cafes.
It includes high resolution screen, display controller, installation cost, as well as 1 year license of industry leading cloud based display management software with 1 year warranty and supportDigital Signage Screen
NPR 98,000.00 – NPR 168,000.00 -
Case Color: Blue
Detection range: Voltage: 3v-7v error 0.1v Current :0-2.5A error 0.01A.It’s suitable for factories, laboratories and personal use.Digital USB Mobile Power Charging Current Voltage Tester Doctor Voltmeter Ammeter
NPR 400.00 -
The 1N4148 is a standard silicon switching signal diode. It is one of the most popular and long-lived switching diodes because of its dependable specifications and low cost. Its name follows the JEDEC nomenclature. The 1N4148 is useful in switching applications up to about 100 MHz with a reverse-recovery time of no more than 4 ns.
Diode 1N4148
NPR 3.00 -
The Schottky Rectifier employs the Schottky Barrier principle in a large area metal-to-silicon power diode. The Schottky Rectifier¿s state-of-the-art geometry features chrome barrier metal, epitaxial construction with oxide passivation and metal overlap contact. It is ideally suited for use as rectifiers in low-voltage, high-frequency inverters, free wheeling diodes and polarity protection diodes.
Diode 1N5822
NPR 15.00 -
The LM3914 is a monolithic integrated circuit that senses analog voltage levels and drives 10 LEDs, providing a linear analog display. A single pin changes the display from a moving dot to a bar
graph. Current drive to the LEDs is regulated and programmable, eliminating the need for resistors. This feature is one that allows operation of the whole system from less than 3V.DIP-18 LM3914N
NPR 75.00 -
Drill bits are cutting tools used to create cylindrical holes, almost always of circular cross-section. Drill bits come in many sizes and have many uses. Bits are usually connected to a mechanism, often simply referred to as a drill, which rotates them and provides torque and axial force to create the hole.
Drill Bit (1.5mm)
NPR 60.00 -
Specification:
– Material:glass fiber
– Color:Blue
– Size:5cm * 5cm * 0.2cm- Drone component
Drone / MultiCopter Power Distribution Board
NPR 350.00 -
Brand new RC screw set containing a total of 49 pieces of silver color screws for Syma X5, X5C and X5C-1.
Drone Screw Set
NPR 200.00 -
The module based on DS1307, The DS1307 serial real-time clock (RTC) is a low-power, full binary-coded decimal (BCD) clock/calendar plus 56 bytes of NV SRAM. Address and data are transferred serially through an I²C, bidirectional bus. The clock/calendar provides seconds, minutes, hours, day, date, month, and year information. The end of the month date is automatically adjusted for months with fewer than 31 days, including corrections for leap year. The clock operates in either the 24-hour or 12-hour format with AM/PM indicator. The DS1307 has a built-in power-sense circuit that detects power failures and automatically switches to the backup supply. Timekeeping operation continues while the part operates from the backup supply.
DS1307 RTC 12C modules
NPR 300.00 -
GP2Y1010AU0F is a dust sensor by optical sensing
system.
An infrared emitting diode (IRED) and an phototransistor are diagonally arranged into this device.
It detects the reflected light of dust in air.
Especially, it is effective to detect very fine particle
like the cigarette smoke.
In addition it can distinguish smoke from house dust
by pulse pattern of output voltage.GP2Y1010AU0F is a dust sensor by optical sensing system
An infrared emitting diode (IRED) and an phototransistor are diagonally arranged into this device
It detects the reflected light of dust in air.
Especially, it is effective to detect very fine particle like the cigarette smoke
In addition it can distinguish smoke from house dust by pulse pattern of output voltage
Compact, thin package (46.0 × 30.0 × 17.6 mm)
Low consumption current (Icc: MAX. 20 mA)
The presence of dust can be detected by the photometry of only one pulse
Enable to distinguish smoke from house dust
Lead-free and RoHS directive compliant
Compliant with RoHS directive (2002/95/EC)Dust sensor Smoke Particle Sensor With Cable GP2Y1010AU0F
NPR 1,790.00 -
The 4N35 is an optocoupler for general purpose applications.It contains a light emitting diode optically coupled to a photo-transistor
EL 4N35 712 Octocoupler
NPR 50.00
