Best Seller Items
Featured Items
-
RFID is useful for sensing and identifying tagged people and objects for access control, automation, and a whole range of different applications. This basic RFID tag/card works in the 125kHz RF range and comes with a unique 32-bit ID. It is not re-programmable. This blank, smooth, and mildly flexible RFID tag is ready for your logo (or hand-drawn scribble).
RFID Cards 125 KHz
NPR 50.00 -
Cool and handy RFID Keychain. Easy to use and easy to take around.
This is a blank 125 kHz RFID Keychain fob – often used for electronic locks or customer identification but also found in other systems where a small and easy to carry tag is desired. The tag contains a NXP S50 chip and an antenna, and is passively powered by the reader/writer when placed a couple inches away.
RFID Key Chain
NPR 60.00 -
This 125Khz USB RFID Card Reader can read RFID card serial number and output to your computer according to the specified format, then management software derives many more functions.
RFID Reader
NPR 1,510.00 -
This Grove-125KHz RFID Reader is a module used to read uem4100 RFID card information with two output formats: Uart and Wiegand. It has a sensitivity with maximum 7cm sensing distance. There is also the electronic brick version of this module.
RFID Sensor 125 KHZ
NPR 1,200.00 -
The SMB130 is a 28 pin DIP module that includes all necessary components for a 13.56 MHz RFID Mifare, aside from a PCB antenna.
RFID Sensor 13.6 MHz +1 RFID Chain+1RFID Card
NPR 700.00 -
-
Clear-lens ultra bright 5-mm RGB LEDs with four leads, common-anode configuration. The water-clear lens projects high brightness for visibility at a distance, but does not inherently provide color mixing like the diffused lens version does.
RGB LED 5mm (Clear)
NPR 20.00 -
An LED light source made of red, green, and blue LEDs (RGB-LEDs) can provide the unique feature of color variability, allowing the user to select the desired color point of the lamp. The white light color accuracy required in the general illumination market is a challenge for LEDs.
RGB LED White 5mm
NPR 20.00 -
Blue/Red/Green Automatic Color Changing 3mm through hole component LED. Cycles through RGB colors then repeats endlessly.
RGB Two-pin LED
NPR 20.00 -
Ribbon cable is really helpful in situations where you need to make a lot of connections without a big mess of wires. Nothing makes a project look more finished than a nice clean wiring harness.
Note: Sold on per meter basis.
Ribbon Cable
NPR 50.00 -
Reliable set of add-ons for your next robotic project. Inside this kit there is a wheel and a gear-motor. The kit is perfect for providing beginners with a cheap and easy to use setup or if you just need a few extra parts.
Robotics Wheel + Motor
NPR 400.00 -
- SanDisk Ultra microSDHC UHS-1 (Micro SD Card)
- 16 GB Menory
- 98MBps transfer speed
- UHS 1
Can be used for Raspberry pi and other purpose.
SanDisk Ultra micro SD Card 16 GB (For Raspberry Pi)
NPR 550.00 -
Push once to turn on, push again to turn off, push again to turn the other side on, one last push and it’s off again! It’s basically a push-button toggle switch that connects and disconnects.
Self-Lock Micro On/Off Push Button Switch
NPR 20.00 -
An assortment of the most common sensors used in electronics.
9 sensors and 3 additional components to interface with the “analog world.”Sensor pack 900 (pre-kitted) by adafruit
NPR 3,600.00 -
Servo tester is a simple servo testing tool that enables us to check whether the servo tester is working or not.
Servo Tester
NPR 400.00 -
74HC595D 8-bit serial-in, serial or parallel-out shift register with output latches; 3-state, NXP, SO16
Shift register 74HC595D SOP
NPR 50.00