touch

Default sorting
Show
16
  • Quick View
    (0)
    Modules

    This capacitive touch sensor module uses the TTP229 integrated circuit, making it easy to add capacitive touch input for projects. It features 16 sensitive touch pads that make an ideal replacement for the traditional keypads.

    16 Channel Digital Capacitive Switch Touch Sensor Module

    NPR 350.00
  • Quick View
    (0)
    Modules
    • Hole distance: 16MM
    • Aperture: 2.5MM
    • Voltage range: 2.4-5V
    • Maximum output current: 500MA
    • PCB size: L23MM *W20MMThe lamp brightness can be adjusted by requirement, it is very to operate.
      It can touch in medium protection, such glass, acrylic, plastic, ceramics and so on, which is very safe.
      Wide application of voltage range, you can choose arbitrarily between 2.4V to 4.5V.
      Simple applied circuit, less peripheral devices, easy processing, low cost.
      Anti power and phone interference, the EFT can reach above +/-2KV; the touch response sensitivity and reliability will not affected by the close distance or multi-angle mobile phone interference.
      Install: Neednrsquo;t to touch copper foil directly,the dimming can be processed across the acrylic glass(above 3mm) or plastic.
      Application: It can control LED module, light and so on.It is available for indoor LED, lighting lamp,DIY automotive lights dimming refit.
      Function:Single touch,using the principle of capacitance touch.The default function is switch, dimming, with brightness memories LED touch dimming.It will light slowly when turn on the lights, and become dark slowly when turn off, which effectively avoid the stimulation to eyes.
      Dimming mode: Non-polar PWM dimming.
      Wiring method: PCB board(VCC,GND) is power input,(LED+, LED-) is connected with the LED lamps of positive and negative level (fingerprint) touch area.

    Capacitive Touch Dimmer

    NPR 250.00
  • Quick View
    (0)
    Raspberry Pi

    3.5 inches touch screen module is designed especially for Raspberry Pi. It transmits data though GPIO, SPI (Serial Peripheral Interface) on the P1 interface. The CPLD on the display module controls display content according to the data transmitted from the SPI interface.

    Raspberry Pi 3.5” TFT with touch screen

    NPR 3,000.00
  • Quick View
    (0)
    Sensors

    The TTP223 is a touch pad detector IC which offers 1 touch key. The touching
    detection IC is designed for replacing traditional direct button key with diverse pad size.
    Capacitive touch allows electronics to sense when your finger is within a few millimetres
    of a surface to simulate a button “press” just like how the pushbutton works. Capacitive
    sensing may be used in any place where low to no force human touch sensing is
    desirable.

    TTP223B Digital Touch Sensor

    NPR 250.00
  • Quick View
    (0)
    Modules
    • Simple to Use, Auto Calibration
    • Output Status Indicator LED
    • Easy to replace mechanical key outputs

    TTP224 4-Channel Digital Touch Sensor Module Capacitive Touch Switch

    NPR 300.00