Uncategorized

Default sorting
Show
16
  • Quick View
    (0)
    Sensors

    The DHT11 is a basic, ultra low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed). Its fairly simple to use, but requires careful timing to grab data.

    Temperature Humidity Sensor DHT- 11

    NPR 410.00
  • Quick View
    (0)
    Uncategorized

    This is an USBasp programmer for uploading source codes (Programs that run your electronic devices from your microwave to your quad-copter) to a Micro-controller unit using standard USB port as input, and the 10 on-board pins as output, and the 6 pins ICSP converter, you can use this to program your arduino with ease. 

    USBASP AVR Programmer(with wire)

    NPR 480.00