L293D is a dual H-bridge motor driver integrated circuit (IC). Motor drivers act as current amplifiers since they take a low-current control signal and provide a higher-current signal. This higher current signal is used to drive the motors.
Warning: Last items in stock!
L293D contains two inbuilt H-bridge driver circuits. In its common mode of operation, two DC motors can be driven simultaneously, both in forward and reverse direction. The motor operations of two motors can be controlled by input logic at pins 2 & 7 and 10 & 15. Input logic 00 or 11 will stop the corresponding motor. Logic 01 and 10 will rotate it in clockwise and anticlockwise directions, respectively.
Enable pins 1 and 9 (corresponding to the two motors) must be high for motors to start operating. When an enable input is high, the associated driver gets enabled. As a result, the outputs become active and work in phase with their inputs. Similarly, when the enable input is low, that driver is disabled, and their outputs are off and in the high-impedance state.
No customer reviews for the moment.
LCD (Liquid Crystal Display) screen is an...
7A @ 6V. 4 x 6.3mm blade terminals. With...
This is a product that is used to provide input...
Single row of 40-holes, female header. Can be...
A pin header (or simply header) is a form of...
The DHT11 is a basic, ultra low-cost digital...
Photo resistors, also known as light dependent...
RF modules are very popular among the Arduino...
While many connectors carry power in addition...
Rs. 799.00 Rs. 999.00
Rs. 2,500.00 Rs. 5,000.00