This is hot! Literally! Apply 5-12VDC and the stainless steel fibers in...
The Arduino Motor Shield allows you to easily control motor direction and speed using an Arduino. By allowing you to simply address Arduino pins, it makes it very simple to incorporate a motor into your project. It also allows you to be able to power a motor with a separate power supply of up to 12v.
Wireless speed up to 150Mbps, ideal for internet surfing and on-line gamingComplies with IEEE 802.11n (Draft 2.0), IEEE 802.11g, IEEE 802.11b standards.Supports 64/128-bit WEP, as well as WPA/WPA2 and WPA-PSK/WPA2-PSK encryptionsSupports WIN XP, VISTA, WIN7/8/10 operating systemWireless Standards: IEEE 802.b/g/nFrequency range: 2.4GHz
This module integrates DHT11 sensor and other required components on a small PCB. The DHT11 sensor includes a resistive-type humidity measurement component, an NTC temperature measurement component and a high-performance 8-bit microcontroller inside, and provides calibrated digital signal output. Note: The cable is not included in the pack
Remote control Operating voltage: DC12V (27A/12V battery x1) Operating Current: 10mA @ 12V Radiated power: 10mw @ 12V Modulation mode: ASK (Amplitude Modulation) Scroll down for further details below
This is a simple water sensor can be used to detect soil moisture when the soil moisture deficit module outputs a high level, and vice versa output low. Use this sensor produced an automatic plant waterer device, so that the plants in your garden without people to manage.
This relay module allows you to combine the processing power of the Arduino to devices that use higher current and voltage. It does so by providing four relays that are rated for 10A at 125VAC. There are four relays that each provide dry contact outputs. That is to say that each relay provides a common (COM) , normally open (NO) and a normally closed...
Latest Arduino UNO sensor Shield V5.0 reserves advantages of Arduino Sensor V4.0,such as lamination design, PCB immersion god process, and mainboard extend all the figures and analog interfaces of Arduino Duemilanove 2009 controller.
Feature: High sensitivity for low-light operation. Low operating voltage for embedded application. Standard SCCB interface compatible with I2C interface. Raw RGB, RGB (GRB4:2:2, RGB565/555/444),YUV(4:2:2) and YCbCr(4:2:2)output format.
HX711 is an electronic scale module, whose working principle is to convert the measured changes in resistance value changes, through the conversion circuit into electrical output. The module communicates with the host computer through TTL 232.